Whirlpool Oven 4-digit F/E-code models (PartSelect chart) F1 E3 Error Code
What the F1 E3 code means
The wiring harness cavity size does not match the value stored in the control - the harness jumpers tell the board a different oven size than it expects.
Likely causes
- Incorrect or mismatched wiring harness fitted → Shop the wiring harness at RepairClinic
- Harness jumpers not agreeing with the actual oven cavity size
- Wrong control board fitted for the model → Shop the control board at RepairClinic
How to fix it — step by step
- Disconnect power for at least 30 seconds and reconnect; note if the code appeared right after a repair
- If it returns, schedule service - the harness jumpers / control pairing must be checked against the tech sheet
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the wiring harness.
Shop the wiring harness at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F1 E3 code
- wiring harness - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Whirlpool Oven 4-digit F/E-code models (PartSelect chart) error codes
See all Whirlpool 4-digit F/E-code models (PartSelect chart) codes & guides →