Whirlpool Oven 4-digit F/E-code models (PartSelect chart) F1 E6 Error Code
What the F1 E6 code means
Latch signal mismatch error on the oven control board - the latch signal the board receives does not match what it expects.
Likely causes
- Door latch switch fault confusing the control → Shop the door latch switch at RepairClinic
- Damaged latch wiring
- Failed control board
How to fix it — step by step
- Disconnect power for at least 30 seconds, then reconnect
- Allow a minute and observe; open and close the door and cancel any clean cycle
- If the code reappears, schedule service - PartSelect directs to control board replacement if the latch checks out → Shop the control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the control board.
Shop the control board at RepairClinic or Amazon
Also tied to this fault: door latch switch - Shop at RepairClinic or Amazon
Parts that commonly fix the F1 E6 code
- control board - Shop at RepairClinic or Amazon
- door latch switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Whirlpool manual is on Whirlpool's support site — you'll need your model number.
Find your model number on the frame inside the oven door or behind the storage drawer. It's the key to the right manual pages and the right parts.
Related Whirlpool Oven 4-digit F/E-code models (PartSelect chart) error codes
See all Whirlpool 4-digit F/E-code models (PartSelect chart) codes & guides →