Rheem Air Conditioner A975_O Error Code
What the A975_O code means
Contactor stuck on, an EcoNet fault code (_O = outdoor unit) displayed on the EcoNet Control Center / Universal Outdoor Control (UODC) of a Rheem variable-speed EcoNet air conditioner/heat pump (A18AZ / P18AZ series, Table 15). Response action: lockout while active, short cycle to restart.
Likely causes
- Compressor contactor welded / stuck closed → Shop the compressor contactor at RepairClinic
- Wiring fault keeping the contactor energized
How to fix it — step by step
- Turn off power to the outdoor unit at the disconnect — the compressor may run with no call
- Have a technician replace the contactor and check its control wiring
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Compressor contactor.
Parts that commonly fix the A975_O code
- Compressor contactor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.