Rheem Air Conditioner A910_O Error Code
What the A910_O code means
Inverter fault — lost rotor position, an EcoNet fault code (_O = outdoor unit) displayed on the EcoNet Control Center / Universal Outdoor Control (UODC) of a Rheem variable-speed EcoNet air conditioner/heat pump (A18AZ / P18AZ series, Table 15). Response action: 3-strikes to permanent lockout.
Likely causes
- Inverter drive unable to track compressor rotor position
- Compressor wiring or connector problem between inverter and compressor
- Failing compressor or inverter drive
How to fix it — step by step
- Turn the system off — a permanent lockout requires service, not repeated resets
- Have a technician check the inverter-to-compressor connections and test the drive and compressor → Shop the compressor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the Inverter drive board.
Shop the Inverter drive board at RepairClinic or Amazon
Also tied to this fault: Compressor - Shop at RepairClinic or Amazon
Parts that commonly fix the A910_O code
- Inverter drive board - Shop at RepairClinic or Amazon
- Compressor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.