Rheem Air Conditioner A100_O Error Code

What the A100_O code means

Communications lost with indoor unit, an EcoNet fault code (_O = outdoor unit) displayed on the EcoNet Control Center / Universal Outdoor Control (UODC) of a Rheem variable-speed EcoNet air conditioner/heat pump (A18AZ / P18AZ series, Table 15). Response action: lockout while active, short cycle to restart.

Likely causes

  1. Damaged or disconnected EcoNet communication wiring between indoor and outdoor units
  2. Indoor unit powered off or its control failed
  3. Communication wiring miswired

How to fix it — step by step

  1. Confirm the indoor unit has power (breaker and switch on)
  2. Turn off power and check the communication wiring connections between the indoor and outdoor units
  3. Have a technician test the communicating controls if wiring is intact

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the A100_O code

No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Rheem Air Conditioner error codes

See all Rheem Air Conditioner codes & guides →