Pentair Pool heater UltraTemp WATER THERM OPEN Error Code
What the WATER THERM OPEN code means
On Pentair UltraTemp heat pump pool heaters, WATER THERM OPEN means the water temperature thermistor circuit is open.
Likely causes
- failed water temperature thermistor
- disconnected or broken thermistor wiring
- connector fault
How to fix it — step by step
- Turn the heat pump off and note the alarm
- Cycle power once and try one restart
- Do not open the cabinet to test the thermistor → Shop the thermistor at RepairClinic
- If the alarm returns, call a pool/spa technician to test and replace the thermistor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: thermistor - Shop at RepairClinic or Amazon
Parts that commonly fix the WATER THERM OPEN code
- temperature sensor - Shop at RepairClinic or Amazon
- thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.