Pentair Pool heater MasterTemp ERR SFS Error Code
What the ERR SFS code means
On Pentair MasterTemp gas pool heaters, ERR SFS means the stack flue temperature is excessive - more than 480F. The front panel buttons are disabled and the heater is reset by cycling power.
Likely causes
- sooted or blocked heat exchanger → Shop the heat exchanger at RepairClinic
- low water flow
- blocked flue/exhaust
- incorrect gas pressure or combustion fault
How to fix it — step by step
- Turn the heater off and do not keep resetting it
- Check that exterior exhaust venting is not visibly blocked
- Restore full water flow before any restart attempt
- Cycle power once only to confirm the code
- Call a pool/spa technician - excessive flue temperature needs combustion and exchanger inspection
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the stack flue sensor.
Shop the stack flue sensor at RepairClinic or Amazon
Also tied to this fault: heat exchanger - Shop at RepairClinic or Amazon
Parts that commonly fix the ERR SFS code
- stack flue sensor - Shop at RepairClinic or Amazon
- heat exchanger - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.