Pentair Pool heater MasterTemp 126 Error Code
What the 126 code means
On Pentair MasterTemp gas pool heaters, code 126 means the water temperature sensor is shorted, per the manual error and fault code table.
Likely causes
- shorted water temperature sensor/thermistor
- damaged sensor wiring
- moisture in sensor connector
How to fix it — step by step
- Press HEATER OFF and note the code
- Try one normal restart after checking for obvious exterior water intrusion
- Do not open the cabinet to test the thermistor → Shop the thermistor at RepairClinic
- If 126 returns, call a pool/spa technician to test and replace the water temperature sensor → Shop the temperature sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: thermistor - Shop at RepairClinic or Amazon
Parts that commonly fix the 126 code
- temperature sensor - Shop at RepairClinic or Amazon
- thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.