Pentair Pool heater MasterTemp E05 Error Code
What the E05 code means
On Pentair MasterTemp gas pool heaters, E05 means the stack flue sensor is open. The front panel buttons are disabled for this fault and the heater is reset by cycling power, following the manual diagnostic diagram.
Likely causes
- failed stack flue sensor
- disconnected or damaged sensor wiring
- sensor connector fault
How to fix it — step by step
- Turn the heater off and note the code
- Cycle power once to reset, as the manual directs for this fault
- Do not open the cabinet to test the flue sensor - it is in the exhaust path
- If E05 returns, call a pool/spa technician to test and replace the stack flue sensor → Shop the stack flue sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the stack flue sensor.
Parts that commonly fix the E05 code
- stack flue sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.