Pentair Pool heater MasterTemp ERR AGS Error Code
What the ERR AGS code means
On Pentair MasterTemp gas pool heaters, ERR AGS is automatic gas shutoff - water temperature after the second pass through the heat exchanger exceeded 140F. The front panel buttons are disabled and the heater is reset by cycling power.
Likely causes
- low water flow causing overheating
- failed automatic gas shutoff sensor/switch → Shop the automatic gas shutoff switch at RepairClinic
- internal bypass fault
- restricted heat exchanger
How to fix it — step by step
- Turn power off to the heater and let the water cool
- Restore full flow - pump on, filter clean, valves fully open
- Cycle power to reset, as the panel buttons are disabled during this fault
- Restart once with proven good flow
- If ERR AGS returns, stop and call a pool/spa technician - this is a gas safety shutoff
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the automatic gas shutoff switch.
Shop the automatic gas shutoff switch at RepairClinic or Amazon
Also tied to this fault: temperature sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the ERR AGS code
- automatic gas shutoff switch - Shop at RepairClinic or Amazon
- temperature sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.