Pentair Pool heater MasterTemp E01 Error Code
What the E01 code means
On Pentair MasterTemp gas pool heaters, E01 means the water temperature sensor is open. Clear the error by pressing the HEATER OFF button.
Likely causes
- failed water temperature sensor/thermistor
- disconnected or broken sensor wiring
- connector fault
How to fix it — step by step
- Press HEATER OFF to clear the error, as the manual directs
- Try one normal restart
- Do not open the cabinet to test the thermistor → Shop the thermistor at RepairClinic
- If E01 returns, call a pool/spa technician to test and replace the water temperature sensor → Shop the temperature sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: thermistor - Shop at RepairClinic or Amazon
Parts that commonly fix the E01 code
- temperature sensor - Shop at RepairClinic or Amazon
- thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.