Kenmore Dryer 110 Series (Whirlpool-Built) L2 Error Code
What the L2 code means
Low or missing line voltage on Kenmore 110-series (Whirlpool-built) Kenmore Elite dryers: the drum may turn but the heater may not turn on, so clothes do not dry.
Likely causes
- One of the two house breakers or fuses for the dryer is tripped or blown
- Loose or incorrect power cord connection → Shop the power cord at RepairClinic
- Low house supply voltage
How to fix it — step by step
- Press and hold START to try to restart the dryer
- Check both house breakers or fuses for the dryer circuit and reset or replace as needed
- Check the dryer is plugged into a properly grounded outlet and the cord connection is tight
- Call an electrician if L2 returns with both breakers on
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the power cord.
Parts that commonly fix the L2 code
- power cord - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes
See all Kenmore 110 Series (Whirlpool-Built) codes & guides →