Kenmore Dryer 110 Series (Whirlpool-Built) F:23 Error Code
What the F:23 code means
Outlet thermistor failure, shorted circuit, on Kenmore Elite dryers (110-series Whirlpool-built platform): the control detects an electrically shorted outlet (exhaust) temperature sensor.
Likely causes
- Shorted outlet thermistor
- Pinched or damaged thermistor wiring causing a short
- Control board fault if sensor and wiring test good
How to fix it — step by step
- Unplug the dryer before any check
- Inspect the thermistor wiring for pinching or damage → Shop the thermistor at RepairClinic
- Test the thermistor resistance; it should be about 10,000 ohms at room temperature
- Replace the outlet thermistor if its resistance is out of range
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the thermistor.
Parts that commonly fix the F:23 code
- thermistor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes
See all Kenmore 110 Series (Whirlpool-Built) codes & guides →