Kenmore Dryer 110 Series (Whirlpool-Built) F:24 Error Code

What the F:24 code means

Inlet thermistor failure on Kenmore Elite dryers (110-series Whirlpool-built platform): the control detects a problem with the inlet temperature sensor, with F:24 listed for the open-circuit condition in service references for this platform.

Likely causes

  1. Failed inlet thermistor
  2. Loose or damaged inlet thermistor wiring
  3. Control board fault if sensor and wiring test good

How to fix it — step by step

  1. Unplug the dryer before any check
  2. Check the inlet thermistor wiring connections → Shop the thermistor at RepairClinic
  3. Test the thermistor resistance against the value in your tech sheet (about 10,000 ohms at room temperature on this platform)
  4. Replace the inlet thermistor if its resistance is out of range

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F:24 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.

Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.

Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes

See all Kenmore 110 Series (Whirlpool-Built) codes & guides →