Kenmore Dryer 110 Series (Whirlpool-Built) AF Error Code
What the AF code means
Restricted or low airflow on Kenmore 110-series (Whirlpool-built) Kenmore Elite dryers: the vent is crushed, kinked or clogged with lint, so air cannot move freely. The dryer may keep running while AF is shown.
Likely causes
- Clogged lint screen
- Vent crushed or kinked behind the dryer
- Lint blockage in the vent run
- Blocked outside vent hood
How to fix it — step by step
- Clean the lint screen thoroughly
- Check the vent behind the dryer is not crushed or kinked
- Clean lint from the whole vent run and make sure the outside hood opens
- Press STOP once to clear the display, then restart; AF returns until airflow is fixed
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the AF code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes
See all Kenmore 110 Series (Whirlpool-Built) codes & guides →