Kenmore Dryer 110 Series (Whirlpool-Built) F:20 Error Code
What the F:20 code means
Heater relay failure on Kenmore Elite dryers (110-series Whirlpool-built platform): the heating circuit is not being controlled correctly, so the dryer may not heat.
Likely causes
- Failed heater relay on the control board
- Heating element or gas heating circuit fault → Shop the heating element at RepairClinic
- Loose heating circuit wiring
How to fix it — step by step
- Unplug the dryer, restore power and try a heated cycle once
- Check airflow and clean the lint screen and vent, as overheating can stress the heat circuit
- Call a technician if F:20 returns or there is no heat, as the relay, board or heating components need testing
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main control board.
Shop the main control board at RepairClinic or Amazon
Also tied to this fault: heating element - Shop at RepairClinic or Amazon
Parts that commonly fix the F:20 code
- main control board - Shop at RepairClinic or Amazon
- heating element - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.
Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes
See all Kenmore 110 Series (Whirlpool-Built) codes & guides →