Kenmore Dryer 110 Series (Whirlpool-Built) E3 Error Code

What the E3 code means

Control mismatch on Kenmore 110-series dryers with electronic controls: the user interface and main electronic control board do not match, which usually appears after a replacement control part was installed.

Likely causes

  1. Incorrect replacement user interface installed
  2. Incorrect replacement main control board installed
  3. Mismatched part numbers between interface and board

How to fix it — step by step

  1. Note the code and stop the cycle
  2. Check the part numbers of the user interface (control key panel) and the main electronic control board against your model number → Shop the user interface control at RepairClinic → Shop the main control board at RepairClinic
  3. Replace any incorrect part with the correct part for your model
  4. Call a technician if you did not replace a part and E3 appears

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the E3 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.

Find your model number inside the door on the frame. It's the key to the right manual pages and the right parts.

Related Kenmore Dryer 110 Series (Whirlpool-Built) error codes

See all Kenmore 110 Series (Whirlpool-Built) codes & guides →