Hayward Pool heater Universal H-Series SF Error Code
What the SF code means
On Hayward Universal H-Series gas pool heaters, SF is a temperature sensor fault - a thermistor input failure reported by the control.
Likely causes
- failed temperature sensor/thermistor → Shop the temperature sensor at RepairClinic
- damaged sensor wiring
- control board fault → Shop the control board at RepairClinic
How to fix it — step by step
- Turn the heater off and note the code
- Cycle power once at the breaker and try one call for heat
- Do not open the cabinet to test the thermistor → Shop the thermistor at RepairClinic
- If SF returns, call a pool/spa technician to test and replace the sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: thermistor - Shop at RepairClinic or Amazon; control board - Shop at RepairClinic or Amazon
Parts that commonly fix the SF code
- temperature sensor - Shop at RepairClinic or Amazon
- thermistor - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.