Hayward Pool heater Universal H-Series bd Error Code
What the bd code means
On Hayward Universal H-Series gas pool heaters, bd means a bad board or a secondary high voltage fault in the heater control.
Likely causes
- failed control board → Shop the control board at RepairClinic
- secondary high voltage fault
- wiring fault inside the heater
How to fix it — step by step
- Turn the heater off at its switch and the breaker
- Note the code for the technician
- Do not open the heater cabinet or test high-voltage circuits
- Call a pool/spa technician to test and replace the board if needed
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the control board.
Parts that commonly fix the bd code
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.