Hayward Pool heater Universal H-Series AC Error Code
What the AC code means
On Hayward Universal H-Series gas pool heaters, AC means the blower vacuum switch is closed when it should be open, a blower/airflow safety fault detected by the control.
Likely causes
- blower vacuum switch stuck closed → Shop the blower vacuum switch at RepairClinic
- blower or vacuum hose fault
- control board fault → Shop the control board at RepairClinic
How to fix it — step by step
- Turn the heater off and note the code before resetting power
- Make sure the pump is running and the heater venting is not visibly blocked
- Cycle power once at the breaker and see if the code returns on a call for heat
- Do not bypass the vacuum switch or open the gas cabinet
- If AC returns, stop and call a pool/spa technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the blower vacuum switch.
Shop the blower vacuum switch at RepairClinic or Amazon
Also tied to this fault: control board - Shop at RepairClinic or Amazon
Parts that commonly fix the AC code
- blower vacuum switch - Shop at RepairClinic or Amazon
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.