Hayward Pool heater Universal H-Series HS Error Code
What the HS code means
On Hayward Universal H-Series gas pool heaters, HS means the maximum return water temperature was exceeded and/or the water temperature rose too rapidly, often a low-flow warning.
Likely causes
- low water flow through the heater
- dirty filter or closed valves
- water temperature sensor fault → Shop the temperature sensor at RepairClinic
- internal bypass fault
How to fix it — step by step
- Turn the heater off and let the water cool
- Make sure the pump is running, the filter is clean or backwashed, and valves to the heater are fully open
- Check skimmer and pump baskets and clear debris
- Restart once with full flow and watch for HS returning
- If HS returns with good flow, call a pool/spa technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the temperature sensor.
Shop the temperature sensor at RepairClinic or Amazon
Also tied to this fault: water pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the HS code
- temperature sensor - Shop at RepairClinic or Amazon
- water pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.