Hayward Pool heater Universal H-Series LO Error Code

What the LO code means

On Hayward Universal H-Series gas pool heaters, LO means the limit string is open - the water pressure switch, vent pressure switch or temperature limit switch has opened and shut the heater down. It is not a low-temperature reading.

Likely causes

  1. low or no water flow - pump off, dirty filter or closed valves
  2. failed water pressure switch → Shop the water pressure switch at RepairClinic
  3. vent pressure switch fault → Shop the vent pressure switch at RepairClinic
  4. temperature limit switch open from overheating → Shop the temperature limit switch at RepairClinic

How to fix it — step by step

  1. Note that LO with the pump off can be normal - start the pump first
  2. Clean or backwash the filter and empty skimmer and pump baskets
  3. Open all valves to the heater fully and confirm strong flow at the returns
  4. Let the heater auto-restart about 2 minutes after flow is restored
  5. If LO persists with proven good flow, call a pool/spa technician - never bypass a limit switch

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the LO code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Hayward Pool heater Universal H-Series error codes

See all Hayward Universal H-Series codes & guides →