Goodman Furnace GMES96 — LED flash-count control Rapid flash
What this problem usually means
Reverse polarity on Goodman GMES96-series furnaces. The 115V line polarity to the furnace or control is reversed, so the control will not operate safely.
Likely causes
- reversed line and neutral wiring
- poor furnace ground
- wiring error at the disconnect or outlet
How to fix it — step by step
- Turn the furnace power switch off
- Do not attempt to rewire line voltage yourself
- Note the code for the technician
- Call a licensed HVAC technician or electrician to correct polarity and grounding
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- 1 flash
- 10 flashes
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
- 4 flashes
- 5 flashes
- 6 flashes
- 7 flashes
- 8 flashes
- 9 flashes
See all Goodman GMES96 — LED flash-count control codes & guides →