Goodman Furnace GMES96 — LED flash-count control 7 flashes
What it should look like on your machine
then it repeats
7 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Low flame sense signal on Goodman GMES96-series furnaces. Flame is present but the flame sensor signal is too weak for the control to trust it; this code is not stored in memory.
Likely causes
- dirty or oxidized flame sensor
- misaligned flame sensor
- low gas pressure or weak flame
How to fix it — step by step
- Turn power off at the furnace switch before doing anything else
- Check the air filter and replace it if dirty
- Restore power and try one heat call
- Flame sensor cleaning and gas checks are technician work on a gas furnace — call a pro if the code returns → Shop the flame sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flame sensor.
Parts that commonly fix it
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- 8 flashes
- 9 flashes
- Rapid flash
- 1 flash
- 10 flashes
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
- 4 flashes
- 5 flashes
- 6 flashes
See all Goodman GMES96 — LED flash-count control codes & guides →