Goodman Furnace GMES96 — LED flash-count control 12 flashes

What it should look like on your machine

then it repeats

12 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Inducer relay error or improper grounding on Goodman GMES96-series furnaces. The control cannot run the inducer relay correctly or detects a grounding problem.

Likely causes

  1. failed inducer relay on the control board → Shop the control board at RepairClinic
  2. poor or missing furnace ground
  3. faulty inducer motor circuit → Shop the inducer motor at RepairClinic

How to fix it — step by step

  1. Check the thermostat is set to Heat and calling for heat
  2. Check the outdoor vent and intake pipes are clear of snow, ice or debris
  3. On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
  4. Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
  5. If the code returns, stop resetting and call a licensed HVAC technician

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Goodman Furnace GMES96 — LED flash-count control problems

See all Goodman GMES96 — LED flash-count control codes & guides →