Goodman Furnace GMES96 — LED flash-count control 9 flashes
What it should look like on your machine
then it repeats
9 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Twinning fault on Goodman GMES96-series furnaces. This applies to twinned (two furnaces sharing one duct system) installations where the controls are not communicating or phasing correctly.
Likely causes
- incorrect twinning wiring
- 24V phasing error between twinned furnaces
- control board fault → Shop the control board at RepairClinic
How to fix it — step by step
- Turn power off to both twinned furnaces
- Check the thermostat is not calling for heat
- Restore power and try one heat call
- Twinning wiring is technician work — call a licensed HVAC technician if the code returns
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the control board.
Parts that commonly fix it
- control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- Rapid flash
- 1 flash
- 10 flashes
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
- 4 flashes
- 5 flashes
- 6 flashes
- 7 flashes
- 8 flashes
See all Goodman GMES96 — LED flash-count control codes & guides →