Goodman Furnace GMES96 — LED flash-count control 5 flashes

What it should look like on your machine

then it repeats

5 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Flame sensed for more than 4.25 seconds with the gas valve de-energized on Goodman GMES96-series furnaces. The control still sees flame (or a flame-like signal) after it told the gas valve to close.

Likely causes

  1. gas valve leaking through or slow to close → Shop the gas valve at RepairClinic
  2. short in the flame sense circuit
  3. faulty flame sensor or wiring → Shop the flame sensor at RepairClinic

How to fix it — step by step

  1. Turn the furnace power switch off and do not keep resetting it
  2. If you smell gas, leave the house and call your gas utility from outside
  3. Note the code for the technician
  4. Call a licensed HVAC technician before using the furnace again

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Goodman Furnace GMES96 — LED flash-count control problems

See all Goodman GMES96 — LED flash-count control codes & guides →