Goodman Furnace GMES96 — LED flash-count control 4 flashes
What it should look like on your machine
then it repeats
4 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Open main or auxiliary temperature limit switch on Goodman GMES96-series furnaces. The furnace overheated and a limit safety opened, most often because of restricted airflow.
Likely causes
- dirty or clogged air filter
- closed registers or blocked returns
- blower failure or wrong blower speed
- restricted ductwork
How to fix it — step by step
- Turn the thermostat down and let the furnace cool
- Replace the air filter if it is dirty or clogged
- Open all supply registers and make sure return vents are not blocked by furniture
- Restore the heat call and watch whether the code returns
- If the limit code repeats, stop and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the limit switch.
Shop the limit switch at RepairClinic or Amazon
Also tied to this fault: blower motor - Shop at RepairClinic or Amazon
Parts that commonly fix it
- limit switch - Shop at RepairClinic or Amazon
- blower motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace GMES96 — LED flash-count control problems
- 5 flashes
- 6 flashes
- 7 flashes
- 8 flashes
- 9 flashes
- Rapid flash
- 1 flash
- 10 flashes
- 11 flashes
- 12 flashes
- 2 flashes
- 3 flashes
See all Goodman GMES96 — LED flash-count control codes & guides →