Amana Washer Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 20 codes covered.
Shop Amana Washer parts at RepairClinic or Amazon
All Washer codes across brands →
Finding your model number: it is inside the door rim or on the back panel.
Front-Load
All Amana Front-Load codes & guides → (8 covered)
- dET — The detergent cartridge is not detected in the dispenser (select models). If you use single-load doses of detergent, Amana says this…
- F5 E2 — The door is not locking properly, so the washer will not start or continue the cycle.
- F7 E1 — A motor speed sensing error: the motor cannot achieve the correct speed for the cycle selected.
- F8 E2 — There is a problem with the dispenser system (select models).
- F9 E1 — Drain times are longer than expected, typically over eight minutes.
- Int — The cycle was paused or canceled. The washer may take 20 to 30 minutes to stop spinning and drain while this code is shown.
- LOC — Control Lock has been activated, so the controls are locked and the washer will not respond to most buttons.
- rL — Items were detected in the washer during the Clean Washer cycle (also shown as F34 on some models). The cleaning cycle must run empty.
Front-Load and Top-Load HE
All Amana Front-Load and Top-Load HE codes & guides → (2 covered)
- F8 E1 — The washer is taking too long to fill (also shown as LF or Lo FL). There is a problem with the water supply going to the washer.
- Sud — There are excessive suds in the washer. Always use HE (High-Efficiency) detergent in this washer.
Top-Load HE
All Amana Top-Load HE codes & guides → (8 covered)
- drn — The washer is not draining properly. Amana notes this can sometimes be an installation problem with the drain hose.
- HC — The hot and cold inlet hoses have been installed incorrectly (reversed): the cold hose is on the hot inlet and the hot hose is on the cold…
- LdL — The lid is not locking, so the cycle cannot proceed.
- LdU — The lid cannot unlock. The washer detects objects on top of the lid preventing it from unlocking.
- lid — The washer lid was left open. If it stays open for more than 10 minutes, the cycle resets and the water in the washer drains out.
- Ofb — The washer load is out of balance. The washer runs a load-balance correction routine to try to rebalance it.
- OL — The washer load was too large. If an overload is detected, the washer drains any water and detergent in the washer.
- PF — The wash cycle was interrupted by a power failure.