Amana Washer Front-Load Int Error Code
What the Int code means
The cycle was paused or canceled. The washer may take 20 to 30 minutes to stop spinning and drain while this code is shown.
Likely causes
- Cycle paused by the user
- Cycle canceled mid-wash
- Washer still spinning down and draining
How to fix it — step by step
- Wait for the washer to stop spinning and finish draining
- Press Pause or Cancel twice and then Power once to remove the code
- If the code stays, unplug the washer for 5 minutes, then reconnect and reselect the cycle
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the Int code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Amana manual is on Amana's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.