Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 9 flashes
What it should look like on your machine
then it repeats
9 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2), the green LED flashes 9 times: a grounding or reversed-polarity fault — the 115V supply polarity is reversed or grounding is improper.
Likely causes
- Reversed line and neutral at the furnace
- Poor or missing earth ground
- Recent electrical work
How to fix it — step by step
- Note which LED is flashing and confirm the thermostat is calling for heat and the furnace has power
- Reset power once (off 30 seconds, then on) and listen for the normal start sequence
- Do not rewire the furnace electrical connections yourself — on two-stage models this code is a polarity/grounding fault
- Call an HVAC technician (or an electrician for the polarity/grounding fault) to test the igniter circuit or correct the wiring
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems
See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →