Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 12 flashes
What it should look like on your machine
then it repeats
12 flashes - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2) the green LED counts the fault: igniter failure — the igniter circuit did not perform as expected during the ignition sequence.
Likely causes
- Cracked or burned-out hot surface igniter → Shop the hot surface igniter at RepairClinic
- Loose igniter connector
- Failed igniter output on the control board
How to fix it — step by step
- Confirm the thermostat is calling for heat
- Reset power once and listen: inducer runs but no glow or ignition points to the igniter
- Stop after one reset if the code returns
- Call a technician to test and replace the igniter
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Parts that commonly fix it
- hot surface igniter - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems
See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →