Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 7 flashes

What it should look like on your machine

then it repeats

7 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2), the green LED flashes 7 times: external lockout — retries exceeded, after the furnace failed to establish flame through all ignition retries.

Likely causes

  1. Failed hot surface igniter → Shop the hot surface igniter at RepairClinic
  2. Dirty flame sensor
  3. Gas supply off or interrupted

How to fix it — step by step

  1. Turn furnace power off and note the code and which LED is flashing for the technician
  2. Confirm the gas shutoff valve to the furnace is open and other gas appliances work
  3. Do not attempt to test or rewire the gas valve circuit
  4. If you smell gas, leave the house and call the gas utility from outside
  5. Call a technician to test the gas valve, igniter, flame sensor and control board → Shop the flame sensor at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems

See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →