Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 10 flashes

What it should look like on your machine

then it repeats

10 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2) the green LED counts the fault: gas flow with no call for heat — the control detects gas flow or a gas valve output when the thermostat is not calling for heat.

Likely causes

  1. Gas valve stuck open or leaking through
  2. Control board gas valve relay stuck closed

How to fix it — step by step

  1. Turn furnace power off and close the gas shutoff valve to the furnace
  2. If you smell gas, leave the house and call the gas utility from outside
  3. Do not try to restart the furnace
  4. Call a technician immediately to test the gas valve and control board → Shop the control board at RepairClinic → Shop the gas valve at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems

See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →