Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) 5 flashes

What it should look like on your machine

then it repeats

5 flashes - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

On Trane two-stage furnaces (XV80, XV90, XV95, XL80, XL90 families, *UD2/*DD2), the green LED flashes 5 times: an open rollout switch or an open control fuse.

Likely causes

  1. Flame rollout from a blocked or cracked heat exchanger
  2. Blocked venting causing a rollout trip
  3. Blown control board fuse from a low-voltage short → Shop the control board fuse at RepairClinic

How to fix it — step by step

  1. Turn the furnace power switch off and close the gas shutoff to the furnace
  2. Do not keep resetting or trying to run the furnace — this code is a safety fault — a tripped rollout switch can signal a dangerous heat exchanger problem → Shop the rollout switch at RepairClinic
  3. If you smell gas, leave the house and call the gas utility from outside
  4. Call a technician to find the cause before the furnace runs again

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Trane manual is on Trane's support site — you'll need your model number.

Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.

Related Trane Furnace Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) problems

See all Trane Two-stage IFC — XV80/XV90/XV95/XL80/XL90 (*UD2/*DD2) codes & guides →