Maytronics Dolphin Pool cleaner Power supply or ON/OFF LED not working
What this problem usually means
The power supply shows no light and the robot will not start — no power is reaching or leaving the power supply.
Likely causes
- No voltage in the wall power socket
- The power supply is not switched ON
- The power cord is not properly connected to the power supply inlet
- The Ground Fault Interrupter (GFCI) is OFF
How to fix it — step by step
- Make sure there is voltage in the wall power socket
- Make sure the power supply is plugged in and turned ON → Shop the power supply at Amazon
- Make sure the power cord is securely connected all the way into the power supply
- Turn OFF the power supply, wait 30 seconds, then turn it on
- If the outlet has a surge protector with test/reset buttons, push the reset button until it clicks
- If the power supply still shows no LED, it has likely failed and needs replacement
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the power supply.
Parts that commonly fix it
- power supply - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.