Maytronics Dolphin Pool cleaner Cleans only part of the pool
What this problem usually means
The robot cleans only part of the pool and never reaches the rest of it.
Likely causes
- Power supply incorrectly positioned
- Not enough blue cable is released for the robot to reach the whole pool
- The filter gets clogged during the cleaning cycle
How to fix it — step by step
- Place the power supply so the robot can freely reach the entire pool area, at least 3 m (10 ft) from the pool and at least 11 cm (4 in) above the ground
- Check that there is enough slack in the blue cable for the robot to reach the entire pool
- Clean the filter basket; if the pool is very dirty, remove the ultra-fine filter panels and rinse them so debris does not harden on permanently
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.