iRobot Robot mop Braava 300 Series Middle NSI blinks red 14 times

What it should look like on your machine

then it repeats

14 blinks - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Braava detected that the motor was getting too hot during a cleaning cycle; the robot stops or will not start.

Likely causes

  1. Drive motor overheating during cleaning

How to fix it — step by step

  1. Turn Braava off and let it cool down before resuming cleaning
  2. Contact iRobot Customer Care if the problem persists after it has cooled down

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot mop Braava 300 Series problems

See all iRobot Braava 300 Series codes & guides →