iRobot Robot mop Braava 300 Series Middle NSI blinks red 2 times
What it should look like on your machine
then it repeats
2 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Braava is stuck in a constricted area and cannot free itself. The 380t manual groups 2 to 6 blinks as 'stuck in its environment and cannot free itself'; the iRobot support chart splits 2 blinks out as the constricted-area case.
Likely causes
- Robot stuck in a constricted or tight area
- Obstacles trapping the robot in the same spot
How to fix it — step by step
- Remove Braava from its current location and place it in a new location
- If Braava keeps getting stuck in the same spot, clear the obstacles there or block off that area while it cleans
- Contact iRobot Customer Care if the problem persists
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related iRobot Robot mop Braava 300 Series problems
- Middle NSI blinks red 3 times
- Middle NSI blinks red 4 times
- Middle NSI blinks red 5 times
- Middle NSI blinks red 6 times
- Middle NSI blinks red 7 times
- Middle NSI blinks red 8 times while charging
- Power button blinking red light
- Power button solid red light
- Solid red light on middle NSI with 2-tone distress sound
- Solid red light on middle NSI with 3 beeps when Sweep or Mop is pressed
- All lights flashing on NSI and buttons, robot beeping while charging
- Middle NSI blinks red 14 times