iRobot Robot mop Braava 300 Series Middle NSI blinks red 5 times
What it should look like on your machine
then it repeats
5 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Braava detected a transition between floor surfaces (such as tile to carpet or a rug edge) and could not move away from it. iRobot's chart points to cloth application as what to check.
Likely causes
- Robot stuck on a floor transition it cannot drive away from
- Cleaning cloth bunched up or overflowing into the middle channel of the removable pad
- Drop switches under the pad stuck or missing their rubber tips
How to fix it — step by step
- Move Braava to a new location away from the transition and restart
- Use a Braava microfiber cloth (white for dry sweep mode, blue for wet mop mode) and make sure it is properly applied — not bunching up or overflowing into the channel in the middle of the removable pad
- Remove the pad and check both drop switches move up and down freely and both have rubber tips installed
- Contact iRobot Customer Care if the problem persists
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related iRobot Robot mop Braava 300 Series problems
- Middle NSI blinks red 6 times
- Middle NSI blinks red 7 times
- Middle NSI blinks red 8 times while charging
- Power button blinking red light
- Power button solid red light
- Solid red light on middle NSI with 2-tone distress sound
- Solid red light on middle NSI with 3 beeps when Sweep or Mop is pressed
- All lights flashing on NSI and buttons, robot beeping while charging
- Middle NSI blinks red 14 times
- Middle NSI blinks red 15 times
- Middle NSI blinks red 2 times
- Middle NSI blinks red 3 times