Hayward Pool cleaner AquaVac 250Li Swivel head rotates repeatedly
What this problem usually means
The swivel head rotates repeatedly after the robot sinks to the pool bottom. Per the manual this is usually trapped air leaving the robot, not a fault.
Likely causes
- Air trapped inside the robot
How to fix it — step by step
- Let the robot run: the swivel head may rotate repeatedly for a few minutes once the robot sinks, and the phenomenon stops once the trapped air is gradually discharged and the robot begins to move regularly
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.
Related Hayward Pool cleaner AquaVac 250Li problems
- Cannot be charged
- Debris escapes from the robot
- Debris leaks at the filter cover
- Does not capture debris
- Does not cover the entire pool
- Float sinks
- Moves slowly or does not move at all
- Runtime shorter than advertised
- Stopped moving mid-pool but swivel head still turning
- Swivel head does not turn or turns slowly