Hayward Pool cleaner AquaVac 250Li Does not capture debris
What this problem usually means
The robot runs but does not capture debris — suction is weak or debris passes through.
Likely causes
- Battery is running out
- Impeller is jammed by large debris
- Suction mouth is clogged
- Impeller is broken
- Debris compartment is full
How to fix it — step by step
- Charge the robot again
- Power off the robot and inspect the hole under the swivel head to see if the impeller is jammed by large debris (make sure the robot is off before servicing) → Shop the impeller at Amazon
- Remove clogged objects from the suction mouth
- Clean both the debris compartment and the filter cover
- If the impeller is broken, contact your dealer for a replacement impeller
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the impeller.
Parts that commonly fix it
- impeller - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.
Related Hayward Pool cleaner AquaVac 250Li problems
- Does not cover the entire pool
- Float sinks
- Moves slowly or does not move at all
- Runtime shorter than advertised
- Stopped moving mid-pool but swivel head still turning
- Swivel head does not turn or turns slowly
- Swivel head rotates repeatedly
- Cannot be charged
- Debris escapes from the robot
- Debris leaks at the filter cover