Hayward Pool cleaner AquaVac 250Li Moves slowly or does not move at all

What this problem usually means

The robot moves slowly, or does not move at all.

Likely causes

  1. Debris compartment is full or filter cover is clogged
  2. Suction mouth is clogged
  3. Filter cover screen is clogged
  4. Rake/brush is deformed
  5. Impeller is jammed

How to fix it — step by step

  1. Clean the debris compartment; flush the filter screen with water to remove small particles, using a soft brush gently if needed, and make sure the filter cover is in place before the next operation → Shop the brush at Amazon
  2. Remove clogged objects from the suction mouth
  3. Lay a deformed rake/brush under sunlight for a few hours to straighten it; if necessary, replace it with a new rake/brush, or run with only one rake/brush
  4. Power off the robot and inspect the hole under the swivel head for an impeller jam

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Hayward Pool cleaner AquaVac 250Li problems

See all Hayward AquaVac 250Li codes & guides →