Hayward Pool cleaner AquaVac 250Li Does not cover the entire pool

What this problem usually means

The robot runs but does not cover the entire pool — areas are consistently missed.

Likely causes

  1. Debris compartment is full
  2. Operation time is shorter than expected (filter dirty or battery not fully charged)
  3. Moving direction is interrupted by water circulation generated by the filtration system
  4. Wheel is jammed

How to fix it — step by step

  1. Clean the debris compartment
  2. Clean the filter compartment and recharge the robot for 6 hours
  3. Turn off the filtration system (as instructed in the filtration manual) at least 15 minutes before robot operation
  4. Check the wheel and remove any debris jamming it

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Hayward Pool cleaner AquaVac 250Li problems

See all Hayward AquaVac 250Li codes & guides →