Hayward Pool cleaner AquaVac 250Li Stopped moving mid-pool but swivel head still turning
What this problem usually means
The robot stopped moving in the middle of the pool, but its swivel head is still turning — it is stuck rather than powered down.
Likely causes
- Robot stopped by an obstacle or large creases in the pool liner
- Robot is held by suction from the main drain of the pool floor
How to fix it — step by step
- Check whether anything is obstructing the cleaner and remove the obstacle
- Turn off the pool filtration system, as instructed in the manual, to release main-drain suction
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.