Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) EEn Error Code
What the EEn code means
Igniter open on newer Goodman single-stage furnaces with the alphanumeric display control. The igniter circuit is open, so the furnace cannot light.
Likely causes
- burned-out or cracked hot surface igniter → Shop the hot surface igniter at RepairClinic
- loose or disconnected igniter wiring
How to fix it — step by step
- Check the thermostat is set to Heat and the furnace power switch and breaker are on
- Confirm the manual gas shutoff valve near the furnace is open (handle parallel to the pipe)
- Turn power off for 30 seconds, then back on, and allow one retry cycle
- Do not keep resetting a furnace that repeatedly fails to light
- If it locks out again, call a licensed HVAC technician and note the code
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the hot surface igniter.
Parts that commonly fix the EEn code
- hot surface igniter - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) error codes
See all Goodman Newer single-stage — alphanumeric display control (RS6621008) codes & guides →