Goodman Newer single-stage — alphanumeric display control (RS6621008) Error Codes
Find your code in the list below. Each page explains what the code means, the most likely causes, step-by-step fixes you can do yourself, and the parts that commonly resolve it. 11 codes covered.
Shop Goodman Newer single-stage — alphanumeric display control (RS6621008) parts at RepairClinic or Amazon
- E10 — Grounding fault or poor neutral connection on newer Goodman furnaces with the alphanumeric display control.
- E11 — Open rollout switch on newer Goodman single-stage furnaces with the alphanumeric display control. The rollout safety opened because flame…
- EE0 — Lockout from excessive ignition retries on newer Goodman single-stage furnaces with the alphanumeric display control (service manual…
- EE1 — Pressure switch circuit closed at the start of a heat cycle on newer Goodman single-stage furnaces with the alphanumeric display control.…
- EE2 — Pressure switch circuit not closed when it should be on newer Goodman single-stage furnaces with the alphanumeric display control. Draft…
- EE3 — Primary limit circuit open on newer Goodman single-stage furnaces with the alphanumeric display control. The furnace overheated, most often…
- EE4 — Flame sensed with no call for heat on newer Goodman single-stage furnaces with the alphanumeric display control. Goodman documents this as…
- EE5 — Open fuse or short in low-voltage wiring on newer Goodman single-stage furnaces with the alphanumeric display control.
- EE6 — Flame-sense signal is low on newer Goodman single-stage furnaces with the alphanumeric display control. Goodman lists this as a…
- EEE — Internal control board fault (internal faults or IRQ loss) on newer Goodman single-stage furnaces with the alphanumeric display control.
- EEn — Igniter open on newer Goodman single-stage furnaces with the alphanumeric display control. The igniter circuit is open, so the furnace…