Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) EE6 Error Code
What the EE6 code means
Flame-sense signal is low on newer Goodman single-stage furnaces with the alphanumeric display control. Goodman lists this as a normal-operation informational code, but a weak signal usually means the flame sensor needs cleaning.
Likely causes
- dirty or oxidized flame sensor
- low gas pressure
- weak burner flame
How to fix it — step by step
- Replace the air filter if it is dirty
- Check the thermostat is calling for heat normally
- Note whether the furnace still heats — this code can appear during otherwise normal operation
- Have a technician clean the flame sensor and check gas pressure if heating becomes unreliable → Shop the flame sensor at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flame sensor.
Parts that commonly fix the EE6 code
- flame sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) error codes
See all Goodman Newer single-stage — alphanumeric display control (RS6621008) codes & guides →