Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) EE2 Error Code
What the EE2 code means
Pressure switch circuit not closed when it should be on newer Goodman single-stage furnaces with the alphanumeric display control. Draft was not proven, so ignition does not proceed.
Likely causes
- blocked vent or intake pipe
- clogged condensate drain
- weak inducer motor → Shop the inducer motor at RepairClinic
- blocked or pinched pressure switch hose → Shop the pressure switch at RepairClinic
How to fix it — step by step
- Check the thermostat is set to Heat and calling for heat
- Check the outdoor vent and intake pipes are clear of snow, ice or debris
- On a high-efficiency model, check the condensate drain line and trap are not clogged or frozen
- Turn power off at the furnace switch for 30 seconds, then back on, and try one heat call
- If the code returns, stop resetting and call a licensed HVAC technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the pressure switch.
Shop the pressure switch at RepairClinic or Amazon
Also tied to this fault: inducer motor - Shop at RepairClinic or Amazon
Parts that commonly fix the EE2 code
- pressure switch - Shop at RepairClinic or Amazon
- inducer motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) error codes
See all Goodman Newer single-stage — alphanumeric display control (RS6621008) codes & guides →