Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) E11 Error Code
What the E11 code means
Open rollout switch on newer Goodman single-stage furnaces with the alphanumeric display control. The rollout safety opened because flame escaped the burner compartment.
Likely causes
- flame rollout from the burners
- blocked flue or vent
- burner misalignment or wrong gas pressure
- cracked heat exchanger
How to fix it — step by step
- Turn the furnace off at the power switch and close the manual gas shutoff if you can do so safely
- Do not reset the rollout switch yourself → Shop the rollout switch at RepairClinic
- If anyone has headache or nausea or a CO alarm sounds, leave the building and call from outside
- Call a licensed HVAC technician to inspect the burners and heat exchanger → Shop the heat exchanger at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the rollout switch.
Shop the rollout switch at RepairClinic or Amazon
Also tied to this fault: heat exchanger - Shop at RepairClinic or Amazon
Parts that commonly fix the E11 code
- rollout switch - Shop at RepairClinic or Amazon
- heat exchanger - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Goodman manual is on Goodman's support site — you'll need your model number.
Find your model number inside the blower/burner compartment door. It's the key to the right manual pages and the right parts.
Related Goodman Furnace Newer single-stage — alphanumeric display control (RS6621008) error codes
See all Goodman Newer single-stage — alphanumeric display control (RS6621008) codes & guides →